Select the Hardware tab and select Properties. Right mouse click on this and then select Properties. Under Unspecified, USB Blaster should be listed. Open the Device and Printers (Control Panel | Devices and Printers). Let me write it as well, in case the wiki is removed: The registry key suggested isn't there on W11 either.īut this worked for me, following the W10 guide: I ran the command "C:\intelFPGA_lite\22.1std\quartus\bin64>quartus_pgm.exe -l", which should list available programmers, and it said "No JTAG hardware available". I just encountered this problem on Windows 11 64-bit. Is there something obvious that I'm doing wrong here? Do I have a bunk USB Blaster? Do I have the wrong hardware or software altogether? Back on the Win7 computer I tried using the command prompt to open altera\11.2sp2\quartus\bin\jtagconfig.exe and saw it read out the message "No JTAG hardware available". In troubleshooting, I also tried installing the same version of Quartus II and the USB blaster on my Win10 laptop, but the driver isn't signed for win10 so I dropped that approach. After connecting the USB Blaster to my Win7 computer for the first time and installing the driver from altera\11.1sp2\quartus\drivers, the USB Blaster shows up in the control panel as "USB-Blaster(Altera)" but Quartus II doesn't show it in the Programmer's Hardware Setup page. Because I have this Ep2c5/ep2c8 dev board, I've been following this video to begin my work with FPGAs:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |